If you are not happy with the results below please do another search
The Mettler Toledo IND range of scales supports the MT-SICS protocol. We advise using DIALOG mode with the scale as it offers a robust communication method. The guide is based on the factory default communication settings for an IND570 scale. Check the current settings for your scale using the indicators menu. This documentation assumes that: […]
See the attached document which describes how to change the settings of the scale. Section numbers listed below refer to this document. This documentation assumes that: The computer is connected to the scale’s interface 1 The scale has been reset to factory standard settings (see section 3.3). The operating mode of the scale has been […]
This FAQ describes how to configure ERP-Scale for use with a Mettler Toledo PS scale using serial communication. The settings are based on the default communication settings of the PS scale. See the attached document for information how to reset the scale to factory settings. ERP-Scale communication settings ERP-Scale parsing settings
Parsing settings:
The settings below are based on the X3 operating manual Edition 2 dated 01/02/2008. They have not been tested using a physical device and should be used as a basis for creating a device in ERP-Scale. Before configuring ERP-Scale, verify that the SMA protocol has been assigned to one of the RS232 ports on the […]