Sartorius X3 scale using an RS-232 connection

You are here:

The settings below are based on the X3 operating manual Edition 2 dated 01/02/2008. They have not been tested using a physical device and should be used as a basis for creating a device in ERP-Scale.

Before configuring ERP-Scale, verify that the SMA protocol has been assigned to one of the RS232 ports on the X3 and check the Baud rate. See section 4.7.3 of the operating manual.

Communication Settings


Select the PC port which the scale is connected to.

Parsing Settings

 

 

Was this article helpful?
Dislike 0
Views: 918
Still have questions? Create a support ticket